| Last Modified: 11-29-2007 | 1.6 U | |
| Service Category: Audio/Visual/Telematics | Section: Park Assist/Monitoring | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM0000013ZZ01OX |
| Title: PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM: TERMINALS OF ECU (2008 Sequoia) | ||
TERMINALS OF ECU
1. CHECK TELEVISION CAMERA ASSEMBLY
(a) Disconnect the V17 camera connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.
|
Terminal No. (Symbol) |
Wiring Color |
Terminal Description |
Condition |
Specified Condition |
|---|---|---|---|---|
|
V17-3 (CGND) - Body ground |
W - Body ground |
Ground |
Always |
Below 1 Ω |
|
V17-4 (CB+) - V17-3 (CGND) |
B - W |
Power source |
Ignition switch ON, shift lever in R |
5.5 to 7.05 V |
If the result is not as specified, there may be a malfunction on the wire harness side.
(c) Reconnect the V17 camera connector.
(d) Measure the waveform according to the value(s) in the table below.
|
Terminal No. (Symbol) |
Wiring Color |
Terminal Description |
Condition |
Specified Condition |
|---|---|---|---|---|
|
V17-2 (CV+) - V17-1 (CV-) |
R - L |
Display signal |
Ignition switch ON, shift lever in R |
Waveform |
If the result is not as specified, the camera may have a malfunction.
|
(e) Using an oscilloscope, check the waveform.
|
2. CHECK NAVIGATION RECEIVER ASSEMBLY
|
|